User`s guide

5. Exit Without Copy: To exit from the Copy Parameters
menu without copying selected parameters to all RS232
ports, type X and then press [Enter]. The APS will exit
from the Copy Parameters menu and return to the command
prompt.
6. Copy Parameters: When you have finished selecting
parameters, press [Esc] to copy the selected parameters to
all APS RS-232 Ports and exit from the Copy Port
Parameters menu. Note that the APS will display a “Sure”
prompt before copying parameters to other ports.
5.7. Save User Selected Parameters
Although this step is optional, it is strongly recommended to
save all user-defined parameters to an ASCII file. This will
allow quick recovery in the event of accidental deletion or
reconfiguration of port parameters. Section 9 describes the
procedure for saving configuration parameters to an ASCII file.
5-15
Configuration