User`s guide

4.2.3. Default Response Message Format
(Sw6)
When commands are invoked, the APS-8M can respond with
either verbose or terse (abbreviated) messages. Response
messages are summarized in Section 11.2. After installation, the
/P command can also set the response format to "none" (Quiet
Mode). When Quiet Mode is selected, the unit will not send
response messages. Note that the /P command can also be used
to select a different Response Message format for each port.
Switch 6 Default Response Message Type
ON Verbose (English Text) *
OFF Terse (abbreviated / numeric)
* = Factory Setting
4.2.4. Default Command Echo (Sw7)
Switch Seven enables or disables the Command Echo. When
enabled, characters sent to the APS-8M will be echoed back to
the control device. Note that the /P command can also be used to
selectively enable or disable the Command Echo at each
individual port.
Switch 7 Default Command Echo
ON Enable*
OFF Disable
* = Factory Setting
Note: SetUp Switch 8 is not currently used.
4-5
Hardware Installation