User`s guide

4.2.1. Default Baud Rate (Sw1, Sw2, Sw3)
SetUp Switches one through three select the default baud rate for
RS232 Ports One through Seven. The default baud rate must
match the rate your control device will use when communicating
with the APS-8M.
Notes:
·
If the control device will communicate via an
external modem connected to one of the RS232
Ports, select a default baud rate that is compatible
with the external modem.
·
The /P command can also be used to select a
different operating baud rate for each port.
·
SetUp Switches one through three do not set the
default baud rate for Port 8 (the Internal Modem
Port). The default baud rate for Port 8 is 9600 bps.
The operating baud rate for Port 8 can also be set
via the /P command.
SW
Default Baud Rate
123
ON ON ON 9600*
OFF ON ON 300
ON OFF ON 1200
OFF OFF ON 2400
ON ON OFF 19.2K
OFF ON OFF 38.4K
ON OFF OFF 57.6K
OFF OFF OFF 115.2K
* = Factory Setting
4-3
Hardware Installation