User's Manual

Table Of Contents

MReX Transceiver User Manual v1.92 Firmware

NOTICE

HAZARD OF EQUIPMENT DAMAGE

• This product is not chemical resistant, detergent, alcohol, aerosol sprays, and/or petroleum products may

damage the front panel. Clean using a soft cloth moistened in water.

• The radio can be damaged if there is any potential difference between the chassis-ground, Serial

signal ground, power (-) input, or antenna coaxial shield. Before connecting any wiring, ensure

that all components are earthed to a common ground point.

• The antenna port will be damaged if signals greater than 13 dBm are injected/received.

• Do not connect any other transmitter to the RF connector or share the antenna with any other

device.

• Extreme Heat or High temperatures can damage MReX components. DO NOT expose or oper-

ate the unit in extreme heat (above 70 degrees Celsius) or leave in direct sunlight or any other

UV source.

• Although this product is designed to be rugged, it will not survive excessive shock or vibration

abuse.

• The MReX IP rating is IP-51. This product is not waterproof or dustproof. DO NOT directly

expose to rain or use in a condensation forming environment.

• When antennas are co-located on a community (shared) site the correct site engineering must be

performed to ensure that RF exposure limits are met.

NOTICE

CARE REQUIRED WHEN TRANSPORTING

Safety and care must be taken when transporting, handling, installing and/or replacing radio equip-

ment.

• Packaging should be adequate to ensure connectors are not damaged

• Store and handle the radio equipment in dry, clean safe environment

• Handle the equipment with care

• Care when stacking MReX boxes must be taken to not damage part of the radio, such as

connectors.