User's Manual
Table Of Contents
- Introduction
- Safety Information
- Operation
- Configuration
- Protocols
- Serial Point to Point Operation
- Input Handling
- Output Handling
- WTE Output Control Protocol
- Store Forward Operation
- Installation
- MReX Firmware Upgrade
- Antenna
- Disclaimer
- Manufacturing marking and labels
- Maintenance
- Product End Of Life
- Product Warranty
- Specification
MReX Transceiver User Manual v1.92 Firmware
Output Hardware Connection
Output Example:
Shown in the example below is the equivalent MReX internal electronics of the output that is shared
with input 1. The output is an open collector suitable for sinking a maximum of 50mA. The ex-
ample is being used to drive an LED from an external supply. Should the output be presented to po-
tential ESD conditions (such as any terminal screw or external connection), ESD devices should be
fitted. If the output is to be used to control a small relay, it is essential that a flyback diode is fitted
across the coil of the relay.
MReX Output Shared with Input 1
© WTE Limited, 2020 – Christchurch New Zealand Page 43 of 59