User's Manual
Table Of Contents
- Introduction
- Safety Information
- Operation
- Configuration
- Protocols
- Serial Point to Point Operation
- Input Handling
- Output Handling
- WTE Output Control Protocol
- Store Forward Operation
- Installation
- MReX Firmware Upgrade
- Antenna
- Disclaimer
- Manufacturing marking and labels
- Maintenance
- Product End Of Life
- Product Warranty
- Specification
MReX Transceiver User Manual v1.92 Firmware
Example 3 - To transmit a message only from a specific remote unit:
In this case, the remote unit is configured to accept WT protocol.
Remote unit configured to have UNIT_ID of “UNIT-10”.
Message payload:
[[UNIT-10]U0[WT1234560A10 Test Message]]
The message transmitted by UNIT-10 will be “Test Message” at 512 baud, but the message may
have been received at a different configured baud rate.
Application of this may be:
A full network operating in a telemetry mode may be transmitting data at 9600 baud. This method
allows a message to be sent through the network at high speed, yet still able to be retransmitted
from a specific unit at a standard low rate for a common POCSAG belt pager.
© WTE Limited, 2020 – Christchurch New Zealand Page 37 of 59