User's Manual
Table Of Contents
- Introduction
- Safety Information
- Operation
- Configuration
- Protocols
- Serial Point to Point Operation
- Input Handling
- Output Handling
- WTE Output Control Protocol
- Store Forward Operation
- Installation
- MReX Firmware Upgrade
- Antenna
- Disclaimer
- Manufacturing marking and labels
- Maintenance
- Product End Of Life
- Product Warranty
- Specification
MReX Transceiver User Manual v1.92 Firmware
RAW Protocol
The Raw protocol uses all default settings to determine the data rate, transport method, cap code
etc. This protocol is the protocol used when using a point to point serial link.
Default transmission settings are configured with the commands:
*TX_BAUD
*TX_CAP
*TX_LEVEL
In addition, the following command is used with RAW protocol:
*RAW_CONFIG
*RAW_CONFIG specifies all RAW protocol parameters.
Format:
*RAW_CONFIG=A,BBB,CC<CR>
Where:
A specifies the time of inactivity timeout in 25ms steps before sending all stored data (max
255).
BBB specifies the number of characters to transmit at once. Messages exceeding the length can
still be sent, but there will be a small delay between each transmission. Transmission delays
may be longer than expected if the MReX determines that the channel is busy.
CC specifies an immediate transmission character (0 if unused). Decimal value of ASCII char-
acter (e.g. 13 for \r)
Example:
*RAW_CONFIG=4,100,13<CR>
© WTE Limited, 2020 – Christchurch New Zealand Page 27 of 59