User's Manual

Table Of Contents

MReX Transceiver User Manual v1.92 Firmware

*BYPASS

Allows messages to be entered via serial to simulate as if decoded across the air. This can be useful

for testing.

Commands take the format:

*BYPASS=[1234567:1]Message_Payload

Where:

[ is the character ‘[’

1234567 is the simulated RIC

: is the character ‘:’

1 is the beep level of the messages

] is the character ‘]’

Message_Payload is any message to inject as if received across the air.

This message will now be processed according to the configured RX_PROTO configuration.

Typical Usage 1:

*BYPASS=[1234567:1]Test Message<CR>

“Test Message” will be added to the received message serial output, as if received across the air.

Typical Usage 2:

*BYPASS=[1234567:1][[01]U0[*REBOOT]]<CR>

The unit will reboot the unit, please refer to WTE Output Control Protocol section on this manual

for more information.

*RSSI

*RSSI returns the receiver signal strength in -dBm. (returns between 0 and -130).

Usage:

*RSSI<CR>