User's Manual
Table Of Contents
- Introduction
- Safety Information
- Operation
- Configuration
- Protocols
- Serial Point to Point Operation
- Input Handling
- Output Handling
- WTE Output Control Protocol
- Store Forward Operation
- Installation
- MReX Firmware Upgrade
- Antenna
- Disclaimer
- Manufacturing marking and labels
- Maintenance
- Product End Of Life
- Product Warranty
- Specification
MReX Transceiver User Manual v1.92 Firmware
*FREQ_OFFSET
*FREQ_OFFSET specifies an offset to compensate for errors and to allow calibration of the in-
ternal frequency reference (in Hz). E.g.
*FREQ_OFFSET =-200<CR>
*SERIAL_LINK
*SERIAL_LINK sets default RS232 point to point configuration. See Serial Point To Point Op-
eration
Usage:
*SERIAL_LINK<CR>
*VER
*VER sends the MReX sign on message back to the user. This is useful to determine the model and
serial number of the unit.
Usage:
*VER<CR>
*IO
Returns all input and output states.
Typical usage:
*IO<CR>
Typical output:
IO=I:01000 O:0
In this typical output, there are 5 inputs shown. Output state follows (valid only if output is con-
figured)
© WTE Limited, 2020 – Christchurch New Zealand Page 18 of 59