User's Manual
Table Of Contents
- Introduction
- Safety Information
- Operation
- Configuration
- Protocols
- Serial Point to Point Operation
- Input Handling
- Output Handling
- WTE Output Control Protocol
- Store Forward Operation
- Installation
- MReX Firmware Upgrade
- Antenna
- Disclaimer
- Manufacturing marking and labels
- Maintenance
- Product End Of Life
- Product Warranty
- Specification
MReX Transceiver User Manual v1.92 Firmware
Base Commands
*REBOOT
*REBOOT forces the unit to immediately restart.
Usage:
*REBOOT<CR>
*CONFIG
*CONFIG displays current configuration.
*CONFIG<CR>
*SAVE
*SAVE saves all configuration settings (all config changes are restored on start-up).
Usage:
*SAVE <CR>
*LIST
*LIST displays all available commands. This command also lists many specific field names that
need to be used with listed commands.
Usage:
*LIST<CR>
*DEFAULTS
*DEFAULTS forces to reset temporary to factory default settings. The user must issue the
*SAVE<CR> command in order to write these default settings to internal memory.
Usage:
*DEFAULTS<CR>
© WTE Limited, 2020 – Christchurch New Zealand Page 17 of 59