User's Manual
Table Of Contents
- Introduction
- Safety Information
- Operation
- Configuration
- Protocols
- Serial Point to Point Operation
- Input Handling
- Output Handling
- WTE Output Control Protocol
- Store Forward Operation
- Installation
- MReX Firmware Upgrade
- Antenna
- Disclaimer
- Manufacturing marking and labels
- Maintenance
- Product End Of Life
- Product Warranty
- Specification
MReX Transceiver User Manual v1.92 Firmware
*RX_ENABLE
*RX_ENABLE Enables or disables the receiver. When the receiver has been disabled, the MReX
will use less than 1uA standby current and will able to be powered from a CR2032 coincell. By de-
fault the receiver is enabled. When the receiver is disabled, the green LED will only flash prior to a
transmission.
Typical Usage:
RX_ENABLE=0<CR>
© WTE Limited, 2020 – Christchurch New Zealand Page 16 of 59