User's Manual
Table Of Contents
- Introduction
- Safety Information
- Operation
- Configuration
- Protocols
- Serial Point to Point Operation
- Input Handling
- Output Handling
- WTE Output Control Protocol
- Store Forward Operation
- Installation
- MReX Firmware Upgrade
- Antenna
- Disclaimer
- Manufacturing marking and labels
- Maintenance
- Product End Of Life
- Product Warranty
- Specification
MReX Transceiver User Manual v1.92 Firmware
*TX_PWR
*TX_PWR set the Transmitter Power Output levels. Levels value ranges from 0 to 127, please use
the following graph to determine the transmitter level value to use. Note that settings above 80 will
have very little effect on output power.
Output Tx Power vs Set Level
Set Level
Examples :
Setting MReX to transmit at 10mW (10dBm ±2dBm):
*TX_PWR=20<CR>
Setting MReX to transmit at 50mW (17dBm ±2dBm):
*TX_PWR=55<CR>
Setting MReX to transmit at 100mW (20dBm ±2dBm):
*TX_PWR=80<CR>
© WTE Limited, 2020 – Christchurch New Zealand Page 13 of 59