User's Manual
Table Of Contents
- Introduction
- Safety Information
- Operation
- Configuration
- Protocols
- Serial Point to Point Operation
- Input Handling
- Output Handling
- WTE Output Control Protocol
- Store Forward Operation
- Installation
- MReX Firmware Upgrade
- Antenna
- Disclaimer
- Manufacturing marking and labels
- Maintenance
- Product End Of Life
- Product Warranty
- Specification
MReX Transceiver User Manual v1.92 Firmware
Transmit Commands
*TX_FREQ
*TX_FREQ specifies the transmit frequency in Hz e.g.
*TX_FREQ=458600000<CR>
*TX_BAUD
*TX_BAUD Specifies the baud rate and channel width of the transmitter when using a protocol that
does not permit a baud rate and channel width to be specified.
This includes whether the modulation is 2 or 4 levels GFSK plus the channel width:
512_25 indicates 512 baud with 25kHz channel spacing (2 level GFSK).
1200_12 indicates 1200 baud with 12.5kHz channel spacing (2 level GFSK).
4800-4L_6 indicates 4800 baud with a 6.25kHz channel spacing (4 level GFSK).
Accepts: 512_25, 512_12, 512_6, 1200_25, 1200_12, 1800_12, 2400_12,
4800_12, 4800-4L_6, 9600-4L_12
Typical usage:
*TX_BAUD=512_25<CR>
*TX_PROTO
*TX_PROTO specifies the protocol to apply for serial input. Accepts WTE and RAW e.g.
*TX_PROTO=WTE<CR>
Note: See protocol section for more details on protocols and configuration.
© WTE Limited, 2020 – Christchurch New Zealand Page 10 of 59