Installation & Assembly

Installing Peel and Stick Glass Tile

This installation guide should be used as a reference, installation should be completed

by a professional and certified tile installer. Glass has sharp edges, please always use

protective gear

Before you start your project

1) Measure the area to determine the amount of tiles you will need. We also recommend you purchase at least

10% more material to account for wastage.

2) Inspect the purchased material for any imperfections.

3) Ensure the area that you will install the tile on is clean, flat and dry. If you are installing the tile in the

kitchen, do not install the tiles in areas directly exposed to heat or any water/moisture. Peel and stick glass

tile should never be installed in wet and high moisture areas. We also recommend unscrewing any electric

plates so you can install the tiles under the plates.

4) Use a level or spacers as a guide and draw a grid or a tile pattern that you wish to install the tiles as. This

also helps you to see where you might need to cut the tiles.

5) Grout is optional. If use grout, un-sanded grout is recommended with a grout joint less than 1/8”.

PLEASE NOTE: PEEL AND STICK GLASS TILES SHOULD NEVER BE INSTALLED ON THE

FLOOR, WET, HIGH MOISTURE AREAS OR OUTDOORS

Tools for Installation

Gloves (Cut Resistant Gloves) Goggles Tile Cutter Sponge

Installation Instruction

1) Layout your tile in the pattern you would like to install.

If any need cutting, please use a tile cutter to cut tiles to

the correct size before step 2 (taking the adhesive

protective layer off).

2) Start with one tile at a time, turn it to the back and

carefully lift the back of the adhesive protective layer.

The red film layer should come off very easily, exposing

the adhesive.

PAGE 1
Installing Peel and Stick Glass Tile This installation guide should be used as a reference, installation should be completed by a professional and certified tile installer. Glass has sharp edges, please always use protective gear PLEASE NOTE: PEEL AND STICK GLASS TILES SHOULD NEVER BE INSTALLED ON THE FLOOR, WET, HIGH MOISTURE AREAS OR OUTDOORS Before you start your project 1) Measure the area to determine the amount of tiles you will need.
PAGE 2
3) Install the tile onto the wall. You do not need to leave space between the tiles. They can be installed right next to each other. The adhesive is very strong, once installed if you do attempt to remove it please note that it might damage the tile, wall or compromise the adhesive strength. The tile is not meant to be reused multiple times. 4) Grouting is optional. You must use un-sanded grout with a recommended grout joint less than 1/8”.