Instructions / Assembly

Wall-mount Sinks Installaon Instrucons
I n s t a l l a t i o n
I n s t r u c t i o n s
M o d e l │
W a l l - m o u n t S i n k s
Dimensions Metric
1 inch = 2.54 cm
1 inch = 25.4 mm
1051 Lea Drive - Collegeville, PA 19426
Tel. [phone] - Fax [phone]
www.wsbathcollections.com - [e-mail]
Page 2/9
3. Insert the anchors into the drilled holes,
screw the mounng hanger bolts.
4. Move the sink back into posion at the
installaon locaon.
5. Secure sink with washers and nuts. Be
careful not to over ghten the bolts to
avoid sink chips and cracks.
6. Proceed to installaon of the drain, trap,
water supply lines, and the sink faucet.
7. Complete the installaon by applying a
thin bead of silicone around the back of
the sink where it meets the wall.
1. Hold the sink up at the desired installaon
locaon. Ensure that the sink is level, then
mark the locaon of the mounng holes
on the back of the sink.
2. Drill pilot holes at the marked locaons of
the sink’s mounng holes.
Installaon Instrucons & Diagrams