Instructions / Assembly
Wall-mount Sinks Installaon Instrucons 
.  
I n s t a l l a t i o n    
I n s t r u c t i o n s  
M o d e l │  
W a l l - m o u n t   S i n k s  
Dimensions Metric 
1 inch = 2.54 cm 
1 inch = 25.4 mm 
1051 Lea Drive - Collegeville, PA 19426 
Tel. 215 513 9400 - Fax 610 831 0215 
www.wsbathcollections.com - info@wsbathcollections.com 
Page 1/9 
Before You Start Installaon 
We recommend that you consult with a profession-
al if you are unfamiliar with installing this type of 
product. WS Bath Collecons accepts no liability for 
any damage to the property; oor, walls, pluming, 
sink, or personal injury during installaon. 
Follow up all local plumbing and building codes. 
Geng Started 
Insure that you have all the requires materials and 
tools for the installaon. 
Install sucient backing behind the nished wall to 
provide adequate support to secure the mounng 
hardware (refer to diagram aached). If the studs 
do not align with the sink, proper wood blocking 
must be installed between the studs where the sink 
will mount. 
Make sure that in-wall plumbing has already been 
prepared. 
Unpack the new sink and inspect it for damage prior 
to installaon.  
Installaon 
1.  Hold the sink up at the desired installaon loca-
on. Ensure that the sink is level, then mark the 
locaon of the mounng holes on the back of 
the sink. 
2.  Drill pilot holes at the marked locaons of the 
sink’s mounng holes.  
3.  Insert the anchors into the drilled holes, screw 
in the mounng hanger bolts.  
4.  Move the sink back into posion at the installa-
on locaon.  
5.  Secure sink with washers and nuts. Be careful 
not to over ghten the bolts to avoid sink chips 
and cracks. 
6.  Proceed to installaon of the drain, trap, water 
supply lines, and the sink faucet. 
7.  Complete the installaon by applying a thin 
bead of silicone around the back of the sink 
where it meets the wall. 
Tools You May Need  
Measuring Tape  Level Pencil 
Stud Finder  Drill Silicone Sealant 
100% 
Bolt  Drywall Anchor Wrench 
Note 
WS Bath Collecons reserves the right to make revisions in the design of prod-
ucts without noce. 










