Instructions / Assembly

Vessel & Countertop Sinks Installaon Instrucons
.
I n s t a l l a t i o n
I n s t r u c t i o n s
M o d e l │
V e s s e l & C o u n t e r t o p
S i n k s
Dimensions Metric
1 inch = 2.54 cm
1 inch = 25.4 mm
1051 Lea Drive - Collegeville, PA 19426
Tel. [phone] - Fax [phone]
www.wsbathcollections.com - [e-mail]
Page 5/9
4. Drill a 2.2” (55 mm) hole at the marked locaon. Hole can be larger than
2.2” depending on the drain hole size of the specic sink.
Note:
A larger hole may be needed depending on the drain hole size of the specic sink or
A cut out may be needed instead of hole depending on the specic conguraon of the sink at its
boom.
1. Posion the sink on the countertop at the installaon locaon.
Note:
Sink shown in round shape for illustraon purpose only. Sink can be of any shape i.e. round, rec-
tangular, among others.
5. Move the sink back into posion at the countertop installaon locaon.
6. Secure sink with washer and nuts. Be careful not to over ghten the bolts
to avoid sink chips and cracks.
7. Proceed to installaon of the drain, trap, water supply lines, and the sink
faucet.
8. Complete the installaon by applying a thin bead of silicone around the
sink where it meets the countertop.
Note:
Mounng ring can be used with glass sinks as a decorave piece (oponal).
2. Trace the sink drain hole onto the countertop.
3. Remove the sink and set aside.
Installaon Instrucon & Diagrams
Mounng Ring for
Glass Sinks oponal)
Connect Drain
Assembly
Connect Trap
1
2
3
4