Instructions / Assembly

Vessel & Countertop Sinks Installaon Instrucons
.
I n s t a l l a t i o n
I n s t r u c t i o n s
M o d e l │
V e s s e l & C o u n t e r t o p
S i n k s
Dimensions Metric
1 inch = 2.54 cm
1 inch = 25.4 mm
1051 Lea Drive - Collegeville, PA 19426
Tel. [phone] - Fax [phone]
www.wsbathcollections.com - [e-mail]
Page 4/9
Before You Start Installaon
We recommend that you consult with a professional if
you are unfamiliar with installing this type of product.
WS Bath Collecons accepts no liability for any damage
to the property; oor, walls, pluming, sink, or personal
injury during installaon.
Follow up all local plumbing and building codes.
Geng Started
Insure that you have all the requires materials and tools
for the installaon.
Make sure that in-wall plumbing has already been pre-
pared.
Unpack the new sink and inspect it for damage prior to
installaon.
WS Bath Collecons reserves the right to make revi-
sions in the design of products without noce.
Installaon
1. Posion the sink on the countertop at the installa-
on locaon.
2. Trace the sink drain hole onto the countertop.
3. Remove the sink and set aside.
4. Drill a 2.2” (55 mm) hole at the marked locaon.
Hole can be larger depending on the drain hole
size of the specic sink or a cutout may be needed
depending on specic conguraon of the sink at
its boom.
5. Move the sink back into posion at the countertop
installaon locaon.
6. Align the sink and drain body assembly with the
drain hole in the countertop.
7. Lower the drain body through the countertop
drain hole unl the sink rests on the countertop.
8. Secure sink with drain, washers, and nuts. Be care-
ful not to over ghten to avoid sinks chips and
cracks.
9. Proceed to complete installaon of the drain, trap,
water supply lines, and the sink faucet.
10. Complete the installaon by applying a thin bead
of silicone around the sink where it meets the
countertop.
Tools You May Need
Damp Cloth Pencil Silicone Sealant
100%
Jigsaw Drill
Note
WS Bath Collecons reserves the right to make revisions in the design of prod-
ucts without noce.