Caution :You must read this before you proceed LOVESEAT 1 of 6
Label Description QTY A Loveseat Base 1 B Front Leg 2 C Back Leg 2 Description QTY Washer Rings 7 Label Picture Picture ① Before Beginnin g Assembly : 2 of 6
Overview Loveseat Base (A) Front Leg (B) Back Leg (C) Front Leg (B) FRONT FACING This LOVESEAT has multiple parts and may require up to some 30 minutes to assemble. To give you an overview of the Club Chair parts, the above picture is to help you put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembly.
Position the Loveseat Base (A) on its back,as shown. Unzip to open pouch take out the box, close the pouch. Open the box and remove 4 wooden legs and the package of hardware accessories in the box. Step 2 Back Leg (C) Back Leg (C) Loveseat Base (A) Washer Ring ① Front Leg (B) Front Leg (B) Position the Loveseat Base (A) on its back,as shown. Install the Front Legs (B) and Back Legs (C) to Loveseat Base (A) by placing Washer Ring(①) , as shown. DO NOT OVER TIGHTEN.
Add or remove Washer Rings(①) where needed to achieve stability. Note:The use of Washer Rings(①) are OPTIONAL and is especially useful to help alleviate slight wobbleness.Some Legs may need more than one Washer Ring whilst some Legs may not need any.Position Loveset right side up and test for stability. Step 4 Stand the Loveseat right side up. Your Loveseat is ready for use.
of 6
