Owner Manual

Step 3
Step 2
Place the Table Top Support (A) on the clean, non-marring surface.
Using the Allen Key (②) attach one of the Legs (B) to Table Top Support (A) with
Bolts (①) & Washer (③).
DO NOT FULLY TIGHTEN THE BOLTS.
Repeat the step with the remaining 2 Legs.
Place the Tabel Top Support (A) face down upon the non-marring surface.
Place the Fixed Ring (C) as shown above.
Using the Allen Key (②) attach the Fixed Ring (C) to Leg (B) using Bolts (①) &
Washer (③).
DO NOT FULLY TIGHTEN THE BOLTS.
Repeat the step with remaining 2 Legs.
2
A
B
A
B
3
1
A
B
C
B
C
3
1
2
Page 4 OF 6