Assembly Instructions Caution : Please read carefully before you proceed TABLE Part List Label Picture Description QTY A Table Top Support 1 B Leg 3 C Fixed Ring 1 D Glass Top 1 Page 1 OF 6
Hardware Label Picture Description QTY ① Bolt (M6*15mm) 7 ② Allen Key (M6) 1 ③ Washer (M6) 7 Assembly Preparation Before Beginning Assembly: Page 2 OF 6
Assembly Steps Overview Glass D) A) B) Fixed ring C) FRONT FACING This Table has multiple parts and may require up to 30 minutes to assemble. To give you an overview of the Table parts, the above picture is provided to help put the various parts into perspective. Please read through the instructions below to familiarise yourself with the parts and steps before assembling. Step 1 Unpack and place all parts on a clean, non-marring surface.
Step 2 B A 3 1 2 B A Place the Table Top Support (A) on the clean, non-marring surface. Using the Allen Key (②) attach one of the Legs (B) to Table Top Support (A) with Bolts (①) & Washer (③). DO NOT FULLY TIGHTEN THE BOLTS. Repeat the step with the remaining 2 Legs. Step 3 2 B 1 C 3 B C A Place the Tabel Top Support (A) face down upon the non-marring surface. Place the Fixed Ring (C) as shown above. Using the Allen Key (②) attach the Fixed Ring (C) to Leg (B) using Bolts (①) & Washer (③).
Step 4 Place the table frame on a LEVEL SURFACE to see if it wobbles. If it wobbles, lift the Table some 30cm to 50cm high from the ground. Keep your feet and toes well away from the drop zone. Drop the table frame freely and vertically with the four legs, hitting the ground, at the same time. This Drop Test will help to ensure that all the Bolts and gaps all reach full alignment status. Test again for evenness on a LEVEL SURFACE. If no wobbles are found, proceed to tighten all the Bolts.
Step 5 D Take off the glass and level it before putting it on. Place Glass Top (D) on the top of the table. Step 6 Your Table is ready for use. This Table can only be used on a flat and level surface.
