Assembly & Installation Instructions
Page 1 of 1
Important Safety information (Please read before proceeding)
1. Remove the fixture, parts and all mounting hardware bags(marked with red tape) from the carton and verify that all parts are present according to the
illustration sheet. All parts must be used as indicated. Do not replace any parts, leave any parts out, or use any parts which are worn out or broken. Failure
to follow the instructions could cause a hazardous situation, voids the warranty and violates the U.L. listing of the fixture.
2. To prevent an electric shock, turn off the main power at the circuit breaker before installing the fixture. NEVER attempt to install, clean or replace
bulbs without shutting off the electricity to the fixture.
3. Never use light bulbs with wattage ratings that exceed the fixtures maximum rating. Always make sure the electric current is turned off before
changing the bulbs.
4. If you experience difficulties installing the lighting fixture or it fails to work as expected, please contact a local qualified licensed electrical contractor.
Assembly Instructions
1. Place the fixture near the place on a table where it is to be installed
2 Take Nipple (5) from parts bag and screw in the Screw Collar Loop (7), and run one Hex Nut (3) with Washer (4) down Nipple (5), then
screw Nipple (5) into Mounting Bar (1). Mounting Bar (1) must be positioned with extruded thread faced into Outlet Box. Nipple (5) must
protrude out from the back of Mounting Bar (1).
3 Attach Mounting Bar (1) to Outlet Box with Outlet Box Mounting Screws (2).
4. Unscrew the Threaded Ring from Screw Collar Loop (7). Take Canopy (6) and pass over Screw Collar Loop (7). Approximately one half of
the Screw Collar Loop exterior threads should be exposed. Adjust Screw Collar Loop (7) by turning assembly up or down in Mounting Bar
(1)
5. After desired position is found, tighten Nipple (5) with one Hex Nut (3) onto screw collar loop (7) and tighten another Hex Nut (3) with
Washer (4) against the Mounting Bar (1).
6. Slip Canopy (6) over Screw Collar Loop (7) and thread on Threaded Ring. Attach Chain with Chain Link (8) with fixture connected to bottom
of Screw Collar Loop (7)..
7. Pass lead wire and ground wire through chain links no more than 3 inches apart, then pass wires through Threaded Ring, Canopy (6),
Screw Collar Loop (7), Nipple (5) and into Outlet Box
8. Connect fixture ground wire to the outlet box ground wire with wire connector supplied; connect the common wire of the lamp cord to
the power supply white wire with wire connector supplied; connect supply wire of the lamp cord to the power supply black wire with wire
connector supplied. Note: This fixture is wired using 2 conductor Lamp cord. The insula on between the two conductors on the lamp cord
can be split down the center for better access to the two conductors. The common wire on the lamp cord is identified as the conductor
with the printed marking and or the ribs embossed in the rubber wire insula on.
9. Raise Canopy (6) to ceiling, verify all wires are securely inside Canopy (6), then secure Canopy (6) in place by tightening Threaded Ring onto
Screw Collar Loop (7).
5. Please contact your local reseller with any assembly or installation questions. Your local reseller can also provide you with replacement parts for
ASSEMBLY AND INSTALLATION INSTRUCTIONS for the Fixture