Installation & Assembly

INSTALLATION INSTRUCTIONS
(TO INSTALL AS A FIXTURE UNIT)
WARNING ! S HUT PO W ER OFF AT FUSE OR CIR CU IT BRE AK E R.
AVERTISSEMENT! COUPER LE COURANT AU NIVEAU DES FUSIBLES OU DU DISJONCTEUR.
Fig. 2
Fig. 3
MOUNTING THE FIXTURE, HARDWIRE VERSION (Fig.2 &
Fig.3)
1. Shut off power at the circuit breaker and remove the old
fixture including the mounting hardware.
2. Carefully remove the fixture from the carton and check that
all parts are included as shown in the illustration.
3. Remove the cord and plug by disconnecting the wire nuts to
the cord (CAUTION: CAN NOT GO BACK TO PLUG
VERSION ONCE THE CORD AND PLUG ARE CUT OFF)
4. Secure the mounting plate (A) to outlet box with screws (B).
The side of the circular strap (A) marked “GND” must face
out.
CONNECTING THE WIRES (Fig. 3)
5. At this point, Connect the electrical wires as shown in Fig. 3,
making sure that all wire connectors are secured. If your
outlet has a ground wire (green or bare copper), connect the
fixture’s ground wire to it. Otherwise, connect the fixture’s
ground wire directly to the mounting backplate by using the
green screw provided.
FINISHING THE INSTALLATION (Fig. 2)
6. Place Fixture Body (K) over the mounting backplate (A) and
secure with screws (C).
7. Insert the bushing (M) into the hole on fixture body (K).
8. Use suction cup (F) to install 1*50W MR16 Bulb (E)
(Included) into the shade (D) (DO NOT EXCEED THE
MAXIMUM WATTAGE RATING!) (NE PAS DEPASSER
LA PUISSANCE NOMINALE MAXIMALE!)
Your installation is now complete. Return power to the outlet
box and test the fixture.
FIXTURE
WIRES
Black or
Smooth
HOUSE
WIRES
Black
(Hot)
FIXTURE
WIRES
White or
Ribbed
HOUSE
WIRES
White
(Neutral)
FIXTURE
WIRES
Bare
Copper
(Ground)
HOUSE
WIRES
Green
(Ground)
Page: 2/2
IMPORTANT: FIXTURE SHOULD BE INSTALLED BY A
QUALIFIED ELECTRICIAN TO ENSURE PROPER WIRING
AND INSTALLATION.
C
OUTLET
BOX
A B
M
D
E
F
K