Owner Manual

Assembly
1 Assembling the light fixture
□ Carefully unpack the fixture and lay out all
parts on clean surface.
□ Prior to installing the bulb, inspect socket for
silica packet. If packet is present, then remove
and throw away. Do not expose it to children or
pets.
□ Place the shade (C) over the socket and secure
with the socket ring (D).
5
.
2 Preparing the light fixture to hang
□ Adjust the height of the fixture as desired by
loosening the set screw (HH). Slide the cord clip (GG)
into the canopy to secure the cord. Once the desired
height is achieved, tighten the set screw (HH) and cut
the excess wire above the canopy (A). Make sure to
leave at least 8" of wire above the canopy (A) for
wiring.