Installation & Assembly

LED Wall Sconce
ASSEMBLY & INSTALLATION INSTRUCTIONS
Please read carefully and save these instructions, as you may need them at a
later date.
CAUTION
Turn off the main power at the circuit breaker before installing the fixture
in order to prevent possible shock.
GENERAL
All electrical connections must be in accordance with local and national
electrical code (N.E.C) standards. If you are unfamiliar with proper
electrical wiring connections obtain the services of a qualified electrician.
Remove the fixture and the mounting package from the box and make
sure that no parts are missing by referencing the illustrations on the
installation instruction.
ASSEMBLY AND INSTALLATION
1. Pull the acrylic lens out (11)from the fixture body.
2. Pull the supply wires (2&8) and the house ground wire (5) out from
the outlet box (1).
3. Make the wiring connections: connect the white supply wire (2) to
the white fixture wire (4); connect the black supply wire (8) to the
black fixture wire (7); connect the house ground wire (5) to the
fixture ground wire(6)using wire connectors (3).
Carefully tuck all wires back into the outlet box (1). Remove the
LED PCB board by removing 4 screws (9). Locate the fixture Pan (12)
over the outlet box (1). Put the mounting screws (10) through the slots
on the fixture pan . Then secure the mounting screws on the fixture
pan into the outlet box tightly. Reinstall the LED panel on the fixture
pan again by the 4 screws (9).
5. Do not exceed the recommended wattage shown on the caution label.
6. Put the acrylic lens over the fixture body by sliding into the edge
of the fixture pan (10).
INSTALLATION IS NOW COMPLETED
4.
.