User Manual

6.7 Hydraulic Oil Tank Check/Fill

Checking Oil Level

1. Ensure mower is on a level surface.

2. Remove hex socket plug from oil level port located in the

front of the tank.

3. Hydro oil should be at the bottom of the threads.

Filling Oil Level

1. Remove hex socket plug

2. Using a funnel, fill tank through oil level port until oil reaches

bottom threads of port.

6.8 Seat Adjustments

The Sport X seat is equipped with the ability to adjust the seat up and down as well as lock the seat in the

down position to avoid seat bounce while standing. (Figure 1)

Height Adjustment:

• Loosen lower seat mounting hardware,

• Removing upper bolts. (Fig. 1A)

• Raise or lower seat to desired setting

and re-install the upper bolts in the

corresponding hole.

• Tighten all hardware.

Seat Lock:

• Loosen T-Knob (Fig. 1B)

• Slide up to top of slot and lock T-Knob

to lock seat in position.

• To fold seat forward, loosen T-Knob

and slide to bottom of slot.

6.9 Spring Platform Adjustment

The factory setting is both springs set at the most forward position.

The more rearward the spring position, the stiffer the platform gets.

Adjustment will be to preference of feel. The two adjustment springs

should at all times, be positioned next to each other not one forward

or back more than the other. To adjust, loosen each spring retaining

bolt from the top just enough to slide it, then tighten with impact

wrench. The nut may spin using hand wrench. NOTE, do not loosen

too much, if the nut falls off, the foot platform will have to be removed

to reinstall.

There is an extra hole for a third spring for operators heavy enough to

bottom out the duel spring stock set up.

Fill Here

Figure 1