User guide
13
2 Warning, Safety and Instructional Decals
• Specific safety warning decals are located on the equipment near immediate areas of potential
hazards.
• Keep all safety signs legible. Remove all grease, dirt and debris from safety signs and
instructional decals.
• Replace worn, damaged or missing safety decals.
• If an attachment or accessory has been installed, make sure current safety decals are visible.
1. Throttle, Slow/Idle
2. Throttle, Fast/Full
3. Blade Engage/Disengage
switch
4. Ignition Switch, Off
5. Ignition Switch, Start/Run
3 Specifications
Engine
• See your engine owner’s manual
• RPM: Full speed 3600 +/- 50 RPM (no load) / Idle 1550 RPM
Electrical System
• Charging System: Internal stator coil
• Battery Type: N/A, Recoil Start
• Battery Voltage: N/A
• Fuses: N/A
Fuel System
• Capacity: 5.6 gal.
• Type of Fuel: Unleaded regular gasoline, minimum 85 octane. Do not use gasoline
containing more than 10% ethanol. Do not mix oil with gasoline.
• Fuel Filter: In line
• Fuel shut-off: On, Off located on tank
Dash Decal
76490056
2
3
4
5
76490001
DECAL,
SHIELD MISSING
76460001
DECAL,
DANGER
BLADE HAZARD