Owner's manual

or in its line of discharge at this or at any time. The discharge chute deflector should be in the down

position.

 Move the engine throttle control to ¾ RPM speed setting.

 Turn on the blade clutch switch. Run blades for approximately one minute. Next, engage and

disengage the blades a few times about 10 seconds apart. If the blades do not start and stop in a few

seconds each time, service the blade brake system.

 With the blades on, disengage the OPC switch to test the Operator Presence Control switch (OPC).

A time delay has been added to the OPC system. The engine should die and the blades should stop

with-in 4-7 seconds after removing your hand from the OPC paddle. If not, service the OPC system.

 Disengage the blades.

 Drive the mower around on a level parking lot. Check that the mower drives in a straight line when

both hand controls are at the full speed position. (If not, refer to How to Perform The Tracking

Adjustment section of this manual)

 As you drive the mower, listen for any unusual noises and test for irregular operation and adjust

or service as necessary.

 Go over the safety information and operating procedures in this manual with the customer. Instruct

each customer in proper operation and observe the customer during their initial operation on a level

parking lot. Repeat until the customer is familiar and comfortable with the basic operation and use of

the mower.

• Dealer:

 Register the mower online within 14 days from the date of retail purchase.

(If unable to use the online registration process, contact your Distributor to

 Registering the product indicates you have successfully completed the pre-

delivery service checklist.

 The limited warranty is considered invalid unless the unit is registered and the

above steps are taken.

 Remember, the purchaser is both your customer and our customer and his/her

satisfaction is very important. Thank you for supporting our products.

The mower is now ready for delivery to your customer