Owner's manual

PRE-DELIVERY SERVICE OF MOWER BY DEALER

Before proceeding with the Pre-Delivery Service of your

mower, please read the safety instructions manual in its

entirety. Only your authorized Wright dealer should perform

the Pre-Delivery Service of the mower.

The Wright Velke Hydro PG is shipped completely assembled and has been adjusted and tested at the

factory. However, due to the jostling of the shipping process and the delivery time lapse, the following

items need to be repeated again before starting the mower. After you have uncrated the mower, follow

these procedures in the order indicated:

 Inspect the mower for any damage, unusual conditions or missing parts.

 Inspect the mower for all of its decals, especially the warning decals. There should be one blade warning

decal on each side of the deck, the “shield missing” decal under the blade belt cover, and the dash

decal.

 Check service, parts and recall bulletins to ensure unit does not need any updates.

 Check (and fill if necessary) engine oil level according to the engine manufacturer’s recommendation.

 Check (and fill if necessary) hydraulic fluid level. Use fully SYNTHETIC oil: Mobil-1 15W-50 (see Hydro

Check/Fill section of this manual).

 Check rear tire pressure – 18 – 22 psi. is recommended. Use the higher pressures for heavier operators.

Front Casters are equipped with non-pneumatic tires and do not require any air. Lowering tire pressure

will affect deck pitch. Always check pitch any time tire pressure is set below recommended

pressures.

 Lubricate all appropriate moving parts (see the Lubrication section of this manual).

 Check the battery (if equipped) to see that the cables are tight and connected properly. The battery is

12 volts and is a maintenance-free battery. Only charge the battery if it will not start the mower properly.

 Add regular unleaded gasoline to fuel tank. (use a minimum of 87 octane gasoline) (You may use

gasoline containing up to 10% ethanol and gasoline containing up to 5% of methanol.)

 Check brake safety interlock.

 Try starting the engine with the parking brake released. (Engine should not start. If engine starts,

service the parking brake locking system)

 Apply parking brake

 Start the engine according to the engine manufacturer’s recommendation. Let the engine run at low -

mid RPM for several minutes to ensure the engine oil reaches all of the engine parts and gets the

hydraulic fluid circulating through the pumps, etc.

 Check if the parking brake locking system prevents the units from being driven while engaged.

If not, service the parking brake locking system.

 Release the parking brake. Next, Release the neutral lock and slowly release steering/brake lever,

one at a time, to make the wheels move in forward and backward rotation.

 Before testing the blade clutch/brake operation, make sure the area is clear and there is nothing

vulnerable to possible thrown objects from under the mower. No one should be near the mower deck

WARNING