Owner's manual

4.3 Control Panel & Steering Control Levers

The Velke Hydro Pistol Grip speed and direction are controlled by releasing and squeezing the

steering brake levers. The OPC paddles must be held down while releasing both neutral latches.

Slowly release the levers to travel forward. Use the Speed Control knob to adjust max speed.

1.Steering / Brake Lever

2.Neutral Latch Lock

3.OPC Paddle

4.Choke

5.Hour Meter

6.Velke Sulky Release

7.Steering Control Linkage

8.Speed Control Knob

9.Ignition Switch

10.PTO Switch

11.Throttle

4.4 Digital Hour Meter

The Velke is equipped with a digital hour meter. Refer to operating/reset instructions below.

The programming specified is:

Default display: Hours

Press once (TMR1): Timer 1, press for 3 sec to reset

Press twice (TMR2): Timer 2, press for 3 sec to reset

Press three times (svc ENG): Will display time remaining until next

service point, hold down to reset. The first interval is 8hr, thereafter

100hr. Beginning 5hr before service point the meter will flash “svc

ENG, in [remaining hours]” every 5 sec.

Shut off engine: Will display how many times the engine has started.

4.5 Fuel System / Shut-Off Valve

The fuel shut-off valve and fuel gauge is located on top of the fuel tank. The valve should be in the

“OFF” position at all times when the mower is not in use. Do Not fill the tank completely. Fill level is

1 inch below the bottom of the fill neck. This will allow for the gas to expand.

4 5 6

11 10 9

Fuel

Valve

Vent

OFF

Fuel

Gauge

Fuel Cap