Owner's manual

2 Warning, Safety and Instructional Decals

• Specific safety warning decals are located on the equipment near immediate areas of potential

hazards.

• Keep all safety signs legible. Remove all grease, dirt and debris from safety signs and instructional

decals.

• Replace worn, damaged or missing safety decals.

• If an attachment or accessory has been installed, make sure current safety decals are visible.

1-Blade engage/disengage switch

2-Ignition switch, Off

3-Ignition switch, Run

4-Ignition switch, Start

5-Apply brake to start

6-Throttle, Slow/Idle

7-Throttle, Fast/Full

8-Speed Control, Neutral

9-Speed Control, Fast

3 Specifications

Engine

•See your engine owner’s manual

•RPM: Full speed 3600 +/- 50 RPM (no load) / Idle 1550 RPM

Electrical System

(Electric Start)

•Charging System: Internal stator coil

•Battery Type: Maintenance Free

•Battery Voltage: 12 Volts

•Fuses: Two, 20 amp, blade type

Fuel System

•Capacity: 5.6 gal.

•Type of Fuel: Unleaded regular gasoline, minimum 85 octane. Do not use gasoline

containing more than 10% ethanol. Do not mix oil with gasoline.

•Fuel Filter: In line

•Fuel shut-off: On, Off located on tank

Dash Decal

76490056

76490050

FIRE HAZARD

WARNING

76490001 Shield Missing

76490017 Choke

76490001

Blade Hazard