Manual

21
6.3.2 Replacing the Cutter Deck Belts
• Stop the engine, remove the key and wait for all moving parts to stop.
• Lower deck to the lowest setting.
• Remove the deck covers.
• Remove the belt by using a ½” ratchet and extension to relieve the belt tension.
• Reinstall in reverse order. Figure shows belt routing and spring compression direction.
6.4 How to Move the Mower if the Engine Won’t Start
Rotate both of the hydro bypass valve levers on the side of each
hydraulic pump about ½ turn counterclockwise. It is important not to
over tighten these levers. Damage may occur to the pump if this valve
is over tightened.
6.5 Hydro Oil Tank Check/Fill
Checking oil
• Ensure mower is on a level surface.
• Remove hex socket plug from oil level port on the back of the tank.
• Hydro oil should be at the bottom of the threads.
Filling oil
• Remove hex socket plug.
• Using a funnel, fill tank through oil level port until oil
reaches bottom threads of the port.