Owner's manual

WARNING

Assembly

hole

Threaded

Removal

holes

Assembly

hole

Tightening will

separate the hub

from the pulley

6.10 Spindle and Drive Pulley Split hub R&R

• Remove 2, ¼” bolts from split hub and install in threaded holes in hub.

• Slowly tighten each bolt, alternating as you tighten bolts against the pulley.

• The hub will separate from the pulley.

• Replace grade 8 bolts and install in reverse order using the assembly holes to tighten hub onto pulley

and spindle shaft.

6.11 Cutting Blades

In order to maintain the best cut, it is important that the blades are well sharpened and not damaged. Bent

or cracked blades or blades with large nicks need to be replaced. Blades must be balanced after

sharpening. To change the blades:

• Stop engine, remove the key and wait for all moving parts to stop.

• Engage the parking brake

• Lift front of mower and secure in the raised position with jack stands.

• Remove the blade nut by turning counterclockwise.

• Install new or re-sharpened blade. (Ensure the blade spacers are reinstalled with the same qty and

location)

• Torque blade bolt to 70-80 ft/lbs / 95-108 Nm

6.12 Transporting

Use a heavy duty trailer or truck to transport the Stander X. Lock brake and block wheels. Securely fasten

the unit to the trailer or truck with straps, chains, cable or ropes.

• Fasten unit to trailer or truck using tie down locations shown in photos.

6.13 Loading and Unloading

Use extreme caution when loading and unloading units on/off trailers or trucks. One full width ramp that

extends beyond the rear tires is recommended rather than individual ramps for each side of the unit. The

ramp should be long enough so that the angles between the ramp and the trailer or truck does not exceed 15

degrees. A steeper angle may cause the mower deck components to get caught as the unit moves from

ramp to trailer or truck. Always put the deck in the transport (up & locked) position when loading or

Front Tie

Down

Rear

Tie

Down