Owner's manual

6.7 Spring Platform Adjustment

The factory setting is both springs set at the most forward position.

The more rearward the spring position, the stiffer the platform gets.

Adjustment will be to preference of feel. The two adjustment springs

should at all times, be positioned next to each other not one forward

or back more than the other. To adjust, loosen each spring retaining

bolt from the top just enough to slide it, then tighten with impact

wrench. The nut may spin using hand wrench. NOTE, do not loosen

too much, if the nut falls off, the foot platform will have to be removed

to reinstall.

There is an extra hole for a third spring for operators heavy enough to

bottom out the duel spring stock set up.

6.8 Lubrication

Grease with No. 2 general purpose lithium base or molybdenum base grease.

• Set parking brake, stop the engine and remove the key.

• Clean grease fittings with a rag.

• Connect grease gun to fitting and pump until grease

begins to ooze out from the bearings.

• Wipe off excess grease.

• Do not use spray lube of any kind on choke and/or

throttle cables.

6.9 Battery Service

The battery is 12 volts and is a maintenance free battery. Charge the battery only if it will not start the mower

effectively. Remove the battery from the mower before charging. Follow the instructions of the battery

charger for proper and safe charging of the battery. Always make sure the Positive terminal is connected to

the Positive battery post and the Negative terminal is connected to the Negative battery post. Reversal could

cause damage to the electrical system.

1. Lift battery box cover to access.

2. Keep the battery and terminals Clean.

3. Keep battery bolts tight.

Battery Cover

Battery

Hold

Down