Owner's manual

WARNING

6 Service and Adjustments

6.1 Tire Maintenance and Pressure

Excessively worn tire tread is dangerous on all hills. Replace drive tires with less than 3/32” of any tread

groove left. Use tires with the tread pattern recommended by Wright Mfg., Inc. only. Keep the tire pressure

in the drive tires between 18 and 24 psi. Higher pressures will cause the tires to have less traction which

will force you to go slower and with less safety and give you a harder ride. Front Casters are equipped with

non-pneumatic tires and do not required any air. They do not have any tread but should be replaced when

excessively worn.

6.2 Height-of-Cut

Before Adjusting the Height-of-Cut be sure the mower blades are not spinning, and

both rear tires have proper air pressure. Check for even tire wear. The height-of-cut

can be adjusted the following ways:

• Pull the deck lift lever on the right hand side of the mower towards the rear of the

mower until it clicks once into the locked transport position. Then set the mower

blade height with the selector pin on the left hand side of the mower. Once the

proper height setting is set on the left, pull back on the deck lift lever on the right

side and then lower the lever towards the front of the machine until it stops at the

set height-of-cut.

Foot Platform OPC

switch is located on the

right side of the cockpit

behind the access panel

Access panel for OPC switch

1. Remove knob and detent pin (A)

2. Pull panel away from unit

3. To install, ensure bottom tabs fit into slots (B)

Height Selector Pin

Deck

Lift

Lever