User manual

i
Use the garage door operator only:
to open and close garage doors
for private use
according to the instructions and safety
regulations in this manual
Any other use shall be regarded as non-compliant
with the intended use.
Correct use of the hand transmitter
The remote control via hand transmitter is only admis-
sible for appliances and equipment in which radio
interference in the transmitter or receiver does not
present a hazard for persons, animals or property or
for which the risk is covered by other safety equipment.
Incorrectly performed structural alterations
result in the risk of injury.
Do not carry out any structural alterations to the door
operator, the garage door or any existing safety equip-
ment which deviate from the measures described in this
manual. Such alterations endanger the operating safety.
The garage door operator must not be used:
in commercial establishments
to operate other objects
in continuous operation
Only operate the garage door operator in dry rooms.
The garage door must be able to be opened and
closed easily by hand and must not jam.
Proper use
Operating conditions
i
Improper use
i
Ensure that the overhead ceiling tracks are always
free of grease and dirt. Dirty overhead ceiling tracks
hinder proper operation.
A 220 - 240 V/50 - 60 Hz power supply must be avail-
able at the place of installation.
Comply with all maintenance intervals
Proper use also includes the regular inspection of the
door and its safety equipment.
Failing to observe all of the information con-
tained in this manual can lead to severe per-
sonal injury, e.g. by being trapped by the door.
Pay attention to all of the information. In order to comply
with the safety regulations in standards EN 13241-1,
EN 12445 and EN 12453, it is particularly important that
this operating and assembly manual is followed during the
installation process.
If a wicket door is installed, the door position
must be monitored. It must be ensured that
the drive is not active if the door is not closed.
42
EN