User manual

29
EN
Contents
i
Dear Customers, ............................................................................................28
These instructions... .......................................................................................28
Key to symbols ..............................................................................................28
Illustrations ...................................................................................................30
Key to the overall view (Figure

) ................................................................31
General safety instructions...............................................................................32
Proper use / operational conditions ..................................................................32
Incorrect use .................................................................................................32
Functional description .....................................................................................33
Blockage detection function .............................................................................33
Obstacle detection function ..............................................................................33
Function of the shutter length compensation system ...........................................33
Important assembly instructions .......................................................................34
Installation of the tubular motor .......................................................................34
Mounting the bearing (Figure

) ...................................................................35
Determine the length of the rotating union (Figure

) ......................................35
Mounting / dismounting the adapter (Figure

) ..............................................35
Mounting the catch with freewheel mechanism (Figure
) * ...........................36
Mounting the catch without freewheel mechanism (Figure
) ...........................36
Dismounting the catch (Figure
) ..................................................................36
Sliding the tubular motor into the rotating union (Figure

) ...............................37
Preparation for use of precision tubes (Figures
-
) .....................................37
Inserting the bearing capsule (Figure

) .........................................................38
Mounting the motor into the bearing (Figure

) ..............................................39
Mounting the roller shutter casing (Figure

/

) ...........................................39
Mounting the roller shutter stopper or an end-rail (Figure
9
) ..............................39
Safety information regarding the electrical connection .........................................40
The motor cable (Figure
j
) ..........................................................................40
Electrical connection of the tubular motor (Figure
k
)
Control of a drive from a single point with a 1-pole switch / button.......................41
Parallel connection of several motors (Figure
l
) ..............................................41
Connection of an external button (230 V/50 Hz) (Figure
m
)
for subsequent adjusting the end point with the set line .......................................42
Use of the set line for manual end point adjustment ............................................42
Connection of a cord circuit setting unit .............................................................42
End point adjustment......................................................................................43
Automatic configuration of the end points ..........................................................43
Manual adjustment of end points .....................................................................44
Manually setting the upper end point and
automatically setting the lower end point ..........................................................44
Automatically setting the upper end point and
manually setting the lower end point ................................................................45
Manually setting the upper / lower endpoints ....................................................46
Test run / modifying the end points..................................................................46
Configuring tubular motors ..............................................................................47
Loading factory settings during the commissioning process ...................................47
Switching the reversing mechanism on / off after obstacle detection .....................48
Switching the automatic roller shutter compensation mechanism on / off ..............48
What to do if... ? ..........................................................................................49
Technical specifications ...................................................................................51
Configuration of KNX/EIB blinds actuators for RADEMACHER tubular motors ...........51
CE Mark and EC Conformity ............................................................................51
Warranty conditions .......................................................................................52