User manual

SET

10 s

Conﬁguring tubular motors

The tubular motors can be individually conﬁgured with the help of a cord circuit setting

unit (22).

The following conﬁgurations are possible.

◆ Reload the factory settings.

◆ Switching the reversing mechanism after obstacle detection on / off.

◆ Switching shutter compensation on / off

NOTE

Further settings can be undertaken with the help of the optionally available RT ConﬁgTool.

Please refer to the information on our Website in relation to this (www.rademacher.de).

Loading factory settings during the commissioning process

Automatic end point conﬁguration is available again once the factory settings have

been loaded.

NOTE

We recommend undertaking these settings with two persons.

IMPORTANT

The tubular motor may not be in operation.

Factory settings:

End points: No end points stored

Automatic adjustment of the end points: activated

Reversing after obstacle detection: activated

Reversing after blockage detection: activated

Shutter compensation: activated

First press the set button (11) on the tubular motor and subsequently press the SET button on the cord circuit set-

ting device (22) (possibly a second person carries this out). Press and hold both buttons for approx. 10 seconds.

Additionally switch on the tubular motor (▲/ ▼). Hold all buttons.

After approx. 10 seconds the tubular motor acknowledges loading of the factory settings by brieﬂy running up

and down.