User manual

42
EN
(a)
13
(d)
(e) (f) (g)
(j)
(b)
(c)
(h)
(i)
(k)
(22)
1.
Connection of an external button (230 V/50 Hz) (Figure
m
) ...
...for subsequent adjusting the end point with the set line
Legend
(a) = set button (11)
(b) = Controller (e.g. 1-pole switch / button)
(c) = Mains 230 V/50 Hz
(d) = Socket box
Pin assignment
(e) = PE green / yellow
(f) = N blue
(g) = L1 black
(h) = (▲) black
(i) = (▼) brown
(j) =
white (set lead)
(k) = external button
IMPORTANT
The set lead (j) must be connected to neutral (f) after configuration of the end points, see figure k.
Use of the set line for manual end point adjustment
The set lead (j) enables the function of the motor set button (11) to be externally
positioned. If the set lead (j) is connected to an external button (see above), you will be
able to use this button as a set button for configuring the end points.
Feed the set line (j) for the motor cable (15) to the designated switching point (e.g.
up to the switch socket).
Use of the set line (j) for initial installation
For initial installation, the roller shutter engineer can connect the motor cable (15) to
a commercially available cord switch device (22) in order to configure the end points
for the tubular motors.
NOTE
Observe the various configuration options for the end points on page 43.
Use of the set line (j) for subsequent modification of the end points:
If you want to subsequently modify the end points for an existing roller shutter installation,
then you must commission an electrician to connect the set lead (j) in accordance with
the connection diagram m to a commercially available button (230 V/50 Hz). You will
then be able to use this button and your roller shutter controller to modify the end points.
Use of the set line (j) after configuration of the end points:
The respective external switch must be disconnected again after the end points are
configured and the motor connection must be configured in accordance with connection
diagram k.
IMPORTANT
The set lead (j) must be connected to neutral (f) after configuration of
the end points.
Connection of a cord circuit setting unit
Open the terminal contacts by pressing the plungers and connect all
of the wires of the motor cable (15) corresponding to their functions,
see figure j.
Plunger