Instructions

EN
67
What to do if... ?
...the motor fails to start?
Possible cause:
◆ Mains power not available.
Solution:
◆ Check the power with a meter to ensure that the supply voltage (230 V/50 Hz)
is available and check the wiring.
◆ Observe especially the information relating to impermissible connection types.
...The tubular motor stops after a short period of time during the
configuration and test procedures?
Possible cause:
◆ The adapter (10) may have slipped off of the magnetic ring (19) on the drive
head (12).
Solution:
◆ Check that the adapter (10) sits flush with the drive head (12) and is fully inserted
into the rotating union (5).
◆ Slide the adapter (10) back so that it is flush with the drive head (12) and slide
the rotating union (5) fully onto the adapter (10), see Figure

. Re-adjust the end
points if necessary, see page 60.
...Automatic adjustment of the lower end point does not work.
Possible cause:
◆ The catch (8) is mounted without the freewheel mechanism.
Solution:
◆ Configure the lower end point manually (see pages 64 and 65).
...The tubular motor stops between the two end points during normal
operation?
Possible cause 1:
◆ The bearing capsule (4) may not be secured with a screw to the rotating union (5)
(see Figure ), causing the rotating union (5) to slip from the motor and the
adapter (10) to come away from the magnetic ring (19) on the drive head (12).
Solution 1:
◆ Check for correct fitting of the bearing capsule (4) and the adapter (10). Use a
self-locking bolt to secure the bearing capsule (4) to the rotating union (5) and
remount the motor in accordance with the information on pages 52 - 56.
Possible cause 2:
◆ The thermal protection system has triggered.
Solution 2:
◆ Wait approx. 20 minutes until the motor has cooled down.
...The roller shutters stop during upward or downward travel?
Possible cause:
◆ Iced-up roller shutters or obstacle on the guide rail.
Solution:
◆ Move the roller shutters a short distance in the respective opposite direction.
◆ Rectify iced-up roller shutters or obstacle.
i
XLIM xx
Technical specifications RolloTube X-line
Motor series
i
20
16
230
50
145
0.64
4
5
0.75
2.5
32
H
I
IP 44
487
45
≤ 70
30
16
230
50
191
0.83
4
5
0.75
2.5
32
H
I
IP 44
546
45
≤ 70
40
16
230
50
198
0.86
4
5
0.75
2.5
32
H
I
IP 44
546
45
≤ 70
50
12
230
50
205
0.89
4
5
0.75
2.5
32
H
I
IP 44
546
45
≤ 70
10
16
230
50
112
0.49
4
5
0.75
2.5
32
H
I
IP 44
487
45
≤ 70
Nm
RPM
V
Hz
W
A
Min.
mm
2
m
R
mm
mm
dB(A)
Rated torque:
No-load speed:
Rated voltage:
Frequency:
Rated output:
Power consumption:
Cyclic duration factor (KB):
Number of wires:
Core cross section:
Plug-in connecting cable (PVC):
Limit switch range: (number of revolutions)
Insulation class:
Protection class:
Protection class in accordance with VDE 700:
Motor length without bearing:
Tube diameter:
Noise pressure level (LpA):