Instructions

EN
66
Configuring tubular motors
The tubular motors can be individually configured with the help of a cord circuit setting
unit (23).
The following configurations are possible.
◆ Reload the factory settings.
NOTE
Further settings can be undertaken with the help of the optionally available RT ConfigTool.
Please refer to the information on our Website in relation to this (www.rademacher.de).
Loading factory settings during the commissioning process
Automatic end point configuration is available again once the factory settings have
been loaded.
NOTE
We recommend undertaking these settings with two persons.
IMPORTANT
The tubular motor must previously have been disconnected from the
power.
Factory settings:
End points: No end points stored
Automatic adjustment of the end points: activated
Reversing after obstacle detection: activated *
Reversing after blockage detection: activated
Shutter length compensation system: activated *
* Please refer to the configuration options in the “Roller shutter drive” menu on page 72
and the “Awning drive” menu on page 80.
First press and hold the set button (11) on the tubular motor and subsequently press and hold the SET button on
the cord circuit setting device (23) (possibly a second person carries this out).
Additionally switch on the mains power. Hold all buttons.
After approx. 10 seconds the tubular motor acknowledges loading of the factory settings by briefly running up
and down.
2.
3.
10 s
A.
B.
+
4.
1.
OFF
or
or
SET
ON
or
or
SET
5.
OFF
or
Symbols and actions when connecting a cord circuit setting unit (23).
or
when connecting an external switch.
Switch off the mains power.
If a cord circuit setting unit (23) is being used, then the rocker switch must be positioned to the centre position.
Release the set button (11) on the tubular motor and the SET button (or the external switch, if connected).
Switch off the mains power again.