Instructions

EN
55
1
5.b
5.c
5.d
5.e
RolloTube X-line Medium
2. Saw a groove in the end of the precision tube 1 in order that the cam
 of the adapter (10) can be completely pressed into the tube.
NOTE
◆ There may not be any play between the groove 1 and the cam  .
◆ The dimensions for groove 1 are dependent on the tubular motor type used, see
illustrations.
Preparation for use of precision tubes (Figures
-
)
Slide the tubular motor into the precision tube.
Mark the four fastening holes and subsequently drill them through the
precision tube in the catch (8).
ATTENTION
◆ Never drill deeper than 10 mm into the catch (8).
◆ Never drill in the area of the drive. Doing so will cause serious
damage.
Screw or rivet the precision tube to the catch (8).
Use four self-tapping sheet metal screws or four pop rivets.
3.
5.
4.
Inserting the bearing capsule (Figure

)
Slide the bearing capsule (4) into the rotating union (5) and subsequently
place the ball bearing (2) onto the axle pin (3).
1.