Instructions

EN
54
4.c
(8)
(20)
(7)
5.a
1.
Dismounting the catch (Figure )
Press the side parts of the retaining clip (7) together and pull the catch
(8) off of the drive adapter (20).
1. 2.
1.
ALUMINIUM
Sliding the tubular motor into the rotating union (Figure

)
Never knock the motor (9) with force
into the rotating union (5).
Doing so will cause serious damage.
First slide the catch (8) into the rotating union (5).
IMPORTANT
The motor (9) must have sufficient free space for rotating unions with internal felt.
Subsequently, press the rotating union (5) fully onto the adapter (10).
IMPORTANT
In doing so, ensure that the adapter (10) does not slip off of the magnetic ring (19) on
the drive head (12) during the assembly process. Otherwise malfunctions may occur,
see page 67.
Preparation for use of precision tubes (Figures
-
)
IMPORTANT
◆ Please only use precision tubes made from aluminium.
◆ The following steps can be left out when using octagonal steel shafts.
Measure the distance between the adapter (10) and the rear third of
the catch (8) and mark this distance on the precision tube.