Instructions

RolloTube C-line
Brief instructions for installation and initial commissioning
CAUTION!
Risk of crushing injuries to the hand when working with
the roller shutter box open.
◆ Never reach into the area of the winding shaft when the
motor is running.
ATTENTION!
The roller shutter may run into the roller shutter box in
self-learning mode and be damaged without rigid shaft
connectors and stoppers.
◆ Connect the roller shutter to the winding shaft (2) with rigid
shaft connectors (1).
◆ Always t two stoppers or an end-rail to the roller shutter.
DANGER!
Risk of fatal electric shock when touching electrical
components.
◆ The electrical connection for the tubular motor and all
work on the electrical systems may only be undertaken by
an authorised qualied electrician.
◆ Carry out all installation and connection work only in an
isolated, de-energised state.
◆ Disconnect all phases of the mains power cable and se-
cure it to prevent any reconnection.
◆ Check that the system is de-energised.
Before you begin, please read this detailed operating manual
of the RolloTube C-line through completely and follow all the
safety instructions and assembly instructions.
Preparation
i
The roller shutter must be equipped with rigid
shaft connectors and stoppers in order to use
the RolloTube C-line in self-learning mode, see
„Preparation“.
1. Switch on the mains power supply.
The RolloTube C-line is ready for operation immediately.
2.
▲
t
Move the roller shutter up and down.
The end positions for the soft stop are
automatically learned during the rst drive
cycles.
3. Subsequently check the direction of travel of the roller
shutter. Switch the lines for the direction of rotation if the
direction of travel is wrong.
Stoppers
Mount a shaft connector (1) at both ends of the winding shaft (2).
In order to do so, follow the information provided in the operating
manual for shaft connectors.
(1) (2)
Electrical connectionCommissioning
Initial installation
At the initial installation, the roller shutter engineer can carry out
the end point setting with the help of the set button on the mo-
tor or with a commercially available cord-switch setting unit,
see page 51 in the operating manual of the RolloTube C-line.
= direction of travel 1
= direction of travel 2
SET
= no function
ON
Pin assignment:
Motor connecting cable > cord-switch setting unit
L1 (black) > ON (black)
L1 (brown) > SET (white)
N Neutral terminal (blue) > N (blue)
PE Earth (green/yellow) > PE (green/yellow)
Connect the motor cable to the connecting
cable (2.5 m) supplied by means of a connec-
tor and make the connection according to the
following wiring conguration.
4
3
L1
N
PE
a
Roller shutter
button
Set button
230 V ~
50 Hz
bcd
Set button
black (a) = L1 direction of travel 1
brown (b) = L1 direction of travel 2
blue (c) = N neutral terminal
green/yellow (d) = PE Earth
white/grey = no function
VBD 671-3 (06.18)
The RolloTube C-line tubular motors are self-learning motors
with a soft stop at both end positions. The end positions for
the soft stop are automatically learned during the rst drive
cycles. This eliminates the need to set the end points or a
learning cycle.
Manual adjustment of end points