User manual
24
EN
i
16. Initial commissioning with the help of the installation wizard
An installation wizard is available in order to help you
congure the RolloTron Comfort quickly and easily. The
wizard automatically guides you through the congura-
tion process for initial commissioning or after a software
reset, see page 59.
Quitting the installation wizard.
Pressing the [M] key for 2 seconds causes the installation
wizard to be cancelled prematurely.
Readiness for operation
The RolloTron Comfort is ready for use as soon as the instal-
lation wizard has nished.
In addition, you can individually customise your settings
and make changes at any time from the main menu and the
system settings menu.
Additional information about conguring the end
points
The end points must be congured in order that the roller
shutters stop at the desired upper and lower positions. It is
imperative that both end points are congured, otherwise
malfunctions may occur.
IMPORTANT
◆ If the RolloTron Comfort is operated without an end
point setting, the drive will continue to run for as long
as one of the two control keys is actuated.
◆ The automatic functions remain blocked until the end
point setting is congured.
◆ Do not set the upper end point right up to the limit stop.
◆ Please ensure that the belt is not excessively slack when
reaching the lower end point.
◆ Release the key promptly and never allow it to extend
beyond the respective end point. Failure to do so can
cause overloading and may damage the roller shutters
and / or drive.
NOTE
◆ After a period of time it may be necessary to recong-
ure the end points as the belt may elongate during the
process of operation due to stretching.