User manual

18
EN
13. Drawing-in and fastening the belt
1.
Insert the mains plug into the socket.
2.
Press the [ Up ] key until the fastening hooks
are easily accessible in the reel compartment.
There is a risk of injury
from the reel.
◆ Never reach into the reel compartment when the
motor is running.
3.
Always remove the mains plug from the socket before
feeding the belt into the top of the RolloTron.
◆ Continue to feed the belt into the device as shown in
the bottom right sectional diagram and subsequently
slide the belt over the fastening hooks from above.
4.
Re-insert the mains plug into the socket.
◆ Press the [ Up ] key until the belt has wound completely
once around the reel.
◆ Pull the belt tight when winding, so that the deection
roller turns at the same time.
5.
Finally remove the mains plug from the socket again
before replacing the reel compartment cover back onto
the reel compartment.
i
Belt
Fastening
hooks
Belt
End of belt
Belt path
in the RolloTron Comfort