User manual

31
EN
21. Removing the RolloTron Standard (e.g. in the event of a move)
1.
+ + + Erase all settings.
Simultaneously press and
hold the buttons for 4
seconds.
2.
Fully close the roller shutters.
Keep the button held down.
3.
In doing so, pull out the belt as far as possible from
the top of the RolloTron Standard.
4.
Remove the cover plate from the lower mounting
holes.
◆ You can remove the front panel by gripping the
small notch in the lower side of the device.
5.
Subsequently release the fastening screws and pull
the RolloTron Standard completely out of the belt
box.
6.
Remove the belt compartment cover.
STOP
There is a risk of injury from the reel.
◆ Never reach into the reel compartment when the
motor is running. Always remove the mains plug
before touching the reel compartment.
i