User manual

27
EN
17.1 Automated solar function; conguring sensitivity
The automated solar function is switched on by setting or
changing the sensitivity.
Congure the brightness at the level which the blinds
should be closed.
Set the current brightness as set limit and
switch on the automated solar function.
1.
+ Simultaneously press the buttons.
2.
The current brightness is now set as the set limit and
the automated solar function is activated.
◆ If this value is exceeded, the roller shutters will roll
down to the light sensor.
NOTE
If you do not intend to use the automated solar function,
it is necessary to remove the solar sensor from the window
pane and protect it from the sunlight or remove the con-
nector from the RolloTron Standard device.
OFF
Automated solar function OFF
ON
Automated solar function ON
Slowly ashing...
◆ ...if the set limit is exceeded.
◆ ...if the current brightness value is
within the measured range while
conguring the set limit.
Rapid ashing
If the current brightness value is outside
the measuring range, the set limit is set to
the measured range limit.
3.
Pay attention to the timer solar LED.
4.
You can switch the automated solar function on and
o as required.
5.
In order to do so, press and hold the
sun key for approx. 1 second.