Installation Instructions

 Do not get close to high-power equipment (full-band harmonics), such as high-power
radio equipment, large machinery, fluorescent lamps, etc. Since the UWB signal is
close to the noise level, any high power multiple harmonics will affect it.
 Away from the liquid, the electromagnetic wave absorption of the liquid in this
frequency band is very obvious.
 Choose the installation in a place with a wide field of vision

1.5 Confirmation before installation
The working environment temperature supports -20℃ ~ 65℃, it is recommended to
use it at room temperature. Different temperatures will affect the stability of the product
to varying degrees.
 In order to ensure the normal operation of the equipment and prolong the service life,
please observe the following precautions:
 Please place the equipment in a ventilated place;
 Avoid equipment in high temperature environment;
 Please keep the signal of equipment away from high-voltage cables;
 Please keep the equipment away from the strong thunderstorm and strong electric field
environment;
 Please unplug the power before cleaning the equipment;
 It is forbidden to wipe the equipment with wet cloth and liquid cleaning;
 Please do not open the case when the equipment is working;
 Ensure that the power supply is consistent with the equipment voltage;
 Please fix the equipment firmly to prevent it from falling;
1.6 Equipment Installation Instructions
1.6.1 Electrical connection
Application Scenario: Take DC12V to supply power to UG-230.
The UG-230 is fixed on the bracket through the mounting ears, and the bracket is generally
painted to prevent rust. The height of the bracket is higher than the driving railing to avoid
blocking between the device antennas.
1.6.2 Fixed
The first consideration for the installation of the anchor is the antenna installation requirements.
Generally, in order to meet the antenna installation conditions, it is necessary to extend the
equipment through the I-beam bracket, which is higher than the driving railing.
During the installation, first fix the 4 mounting ears on the UG-230 with the hexagon socket
screws through hexagon socket head screwdriver.
Fixing the UG-230 mounting ears on the I-beam bracket by screws, and fixing the power supply
wire harness on the bracket to ensure stability.