Operation Manual

2 3
ROBOTZOMBIE™ APOCOLYPSE!
Contents
1x RobotZombie™
1x Zombie Blaster
3x Foam Darts
1x Instruction Manual
RobotZombie™
Zombie Blaster
3 Foam Darts
BATTERY DETAIL
Congratulations on your purchase of RobotZombie™!
At one time just a working robot, RobotZombie™ was infected with a mysterious Zombie virus and
is now on the prowl to spread the infection.
Inside you will find instructions on how to not only battle this mechanical menace in Zombie
Infection Mode, but also how to take direct control and access his movements and functions!
BATTERY REQUIREMENTS:
Your robot is powered by 4 x “AA” size Alkaline batteries
(2 batteries in each foot - not included).
Your Zombie Blaster is powered by 3 x “AAA” batteries (not included).
RobotZombie™
: Base of Feet Zombie Blaster: Side View
IMPORTANT BATTERY INFORMATION:
•Useonlyfreshbatteriesoftherequiredsizeandrecommendedtype
•Donotmixoldandnewbatteries,differenttypesofbatteries[standard(Carbon-Zinc),
Alkaline or rechargeable] or rechargeable batteries of different capacities
•Removerechargeablebatteriesfromthetoybeforerechargingthem
•Rechargeablebatteriesareonlytobechargedunderadultsupervision
•Pleaserespectthecorrectpolarity,(+)and(-)
•Donottrytorechargenon-rechargeablebatteries
•Donotthrowbatteriesintothere
•Replaceallbatteriesofthesametype/brandatthesametime
•Thesupplyterminalsarenottobeshort-circuited
•Removeexhaustedbatteriesfromthetoy
•Batteriesshouldbereplacedbyadults
•Removebatteriesifthetoyisnotgoingtobeplayedwithforsometime
•RobotwilljuststopwhenbatterypowergetsVERYlow.Poweroffandreplaceallbatteries.
•Somelightingorsunlightcaninterferewithinfra-redsignals.
NOTE
LOW BATTERY INDICATORS:
When RobotZombie™ ’s batteries grow weak, your RobotZombie™ will move and walk very slowly
When this occurs, power robot OFF and replace all batteries.
When the Zombie Blaster’s batteries grow weak, RobotZombie™ will no longer respond to the
commands. When this occurs, replace all batteries.
BATTERY INSTALLATION:
•BesuretherobotpowerbuttonisintheOFFpositionbeforeinstallingor
changing batteries.
•RemovethebatterycoverswithaPhillips/crossheadscrewdriverasshown
(not included).
•Installrecommendedbatteriesasshown,makingsurebatterypolarityiscorrect
(batteries not included).
•Replacebatterydoorsandcarefullytightenallscrews.
1.5V “AAA” LR03/UM4 1.5V “AAA” LR03/UM4 1.5V “AAA” LR03/UM4
1.5V“AA” LR6/UM3 1.5V“AA” LR6/UM3 1.5V“AA” LR6/UM3 1.5V“AA” LR6/UM3